Realtime Sync Slow and Network sync doesn't work
Posted: Wed Oct 29, 2014 8:58 pm
I just installed BestSync 2014. After enabling realtime sync, I noticed that if I change a file, it gets added to the queue, and then sits there doing nothing for about 5 seconds before transferring the file. Why does it wait so long, and is there a way to remove the wait time before transferring the file?
Second problem is the source is a network drive. BestSync does not real time detect changes on the network drive at all. The network drive is a linux samba connection.
So far the only way I've found to update a change on the network side is to stop the task monitoring the changes and start it again.
What are my options here to improve this? Is there a way to get the mapped drive to detect changes? If not, is there a faster way to initiate a full scan than stopping and starting the task?
Any help would be appreciated.
Thanks
Second problem is the source is a network drive. BestSync does not real time detect changes on the network drive at all. The network drive is a linux samba connection.
So far the only way I've found to update a change on the network side is to stop the task monitoring the changes and start it again.
What are my options here to improve this? Is there a way to get the mapped drive to detect changes? If not, is there a faster way to initiate a full scan than stopping and starting the task?
Any help would be appreciated.
Thanks